The Jalopy Journal
damn, i feel your frustration. i ran into this same deal on my 52. all new components, everything ohm'd right. fuel gauge would stop at 3/4". that...
This should be an interesting discussion. My opinions, newer fuel injected stuff, no. It doesnt not benefit from more than say a 30 second warm...
[ATTACH]
Not bad for so little time behind a brush. Nothing to it but practice. I started on a piece of glass as it is the hardest surface to work. Once...
Design for one of my tshirts i did
I personally use kilmat. Have had great results over several builds with it. I also use a heat gun to preheat the pieces before sticking them...
Im 35, ive been around cars and shops since i was in diapers. I have built several cars and trucks of all styles. But i agree with previous posts...
Drawing of my car
Ill play
Firstinsteele, thanks for chiming in with those words of wisdom. Glad you took time out of your day to help spitball some possibilities with the...
yes there is a vibe associated with it, it can be felt in the floor pans and all the way up through the shifter. And no, car has to be rolling...
Yes, when we did the rear we replaced them as well. Yeah, i noticed timkin has gone over seas lately. Very sad
Yes the noise can be recreated on a hoist. Problem is trying to locate it as it seems to travel through the whole drivelive and floorpan of the car.
I doubt its the muffler bearings, i checked them when i changed the blinker fluid.
Will try to adjust angles on the driveshaft. Will make noise in air and on road. Am also thinking i may have to check out the flexplate as well.
Separate names with a comma.
The Jalopy Journal