The Jalopy Journal
I ordered the Moroso one and it ended up being too thick to allow my cotter pin to go through the hole. As it turns out, the stock GM one does...
I haven't found one on the Edelbrock webpage. thanks pprather. I had seen that one show up before, but I hadn't seen the reviews that indicate...
What grommet/nylon bushing are you guys using to connect 60's GM throttle rods to a newer edelbrock? The hole is too big for the stock rubber...
OK, thank you
If anyone has a 327 intake, casting # 3844459, could you tell me the distance between the passenger and driver side studs? Thanks.
As it turns out, I may have to use an edelbrock intake after all. I definitely want to use the heat insulator, but I don't think Edelbrock makes...
I got the edelbrock 1403 in and also the heat insulator gasket # 9266. Of course the edelbrock will bolt directly to the Rochester intake, but the...
I don't mean to get overly technical or deep in the history. The intent is more to make it easier when reading articles or the forums when people...
I keep learning this, and then I'll forget it again, so I want to get it in one place so I can make it easier. What Carb brands turned into what...
Here is a picture of the front of the head on my 327. I'm unsure what this head is. Would it be compatible with the stock 327, 300hp intake from...
Separate names with a comma.