The Jalopy Journal
tape and an end wrench?
Ran into the similar thing with my sister's Camaro. Due to back issues, 4 speeds are out, and it's automatics only, so her Camaro has gone from...
As far as style of car, it sounds like I'm headed in the same direction; track nosed 26 T roadster on a 30 AA frame with parallel front leaf...
Looking at the closeup pic, it does look like an tiny Pontiac like Indian head is below the hood ornament looking thing in the center cap and GM...
I actually driven something with a wheel shaped like that, but I can't for the life of me remember what it was. From the horn button I'd guess...
A lot of these cars (even the two man cars) had frames that followed outside the body outline. Some race cars with cut downs instead of doors...
Glad to see this thread wasn't a how-to on putting a 9" Ford rear end mounted on semi eliptics under under a SBC powered Ford hot rod. Has...
A lot of Mopar alternators had/have 2 grove pulleys on them stock. Not uncommon on Dodge pickups. Late 80s/early 90s AC setup used four belts...
A lot of headers built in the sixties for engines with that port arrangement (Chev, Buick, Olds, Cad, and Pontiac) were commonly built with one...
I don't think the 255 Ford should be thrown in the same pile as the 301 Pontiac. It's rather more like the 273 Mopar and it's bore is actually...
Right on Rikster! Looks like the broken plastic model you had as a kid right after your little brother just smashed it, and more than a little...
I getting so tired of listening to other peoples' noise polution I want to scream. You're bombarded by it everywhere. Just about every store you...
The fluid coupling(s) in the dual range hydro doesn't (don't) contain a third element to multiply torque at stall (the reason for a four gear box...
Building an axle from scratch to connect to the ENTIRE MG upright with the stock MG control arm pins sounds like the easiest and most elegant...
King pin inclination is the angle of the king pin from perpendicular to the ground plane (again usually stated in number of degrees) looking at...
Separate names with a comma.