The Jalopy Journal
When I first started out, my used machine didn't have a flaring tool. I'd cut the flares off of a Y pipe and welded them on. The manifold ends of...
Yes you will meed 6V cables to carry the amperage. Clean and wire brush every connection in the starter system including the grounds. Clean the...
Leave the cap loose and see if it boils over. I'm betting that the temp ga. is reading incorrectly. I spent a bunch of money chasing an over...
[IMG] you had to see it run to understand. Not as famous as others but very impressive to watch.
[IMG] bed I made 30 years ago bed pockets and all...no bed stiffening beads though. I had the panels bent up and then assembled it.
buy a dirty Motors Manual off of Ebay you don't need a fancy clean one. GM and Ford test using different terminals. I look it up every time. I...
35 up for the radiator cap inside the grille shell. Do a Google image search just change the year. Should be pretty easy to find.
[IMG] Yes my Hudson wheel fits on my F100 shaft.
look it up... Fords and GMs are done differently so internet answers from memory aren't always accurate.
I'd move the core support or make a fan shroud. Electric water pumps are for lazy people.
[IMG] A photo does not do this justice
you can't change the center line of the crank and trans so don't worry about it. Lots of engine center lines are off set to the side. It is not...
I've run 39 trans' behind several sbcs and never blown one. Am I lucky or or just a good driver? If you drive it like a race car it will break...
Never used anything but the factory pump for the engine. No risers, no gimmicks, just factory water pumps. Never had an over heating problem!
Half of the 32 Ford PUs at the shows have 34 cabs with the 3rd belt molding. Most likely "re-cabbed along the way. After all these years you can't...
Separate names with a comma.