The Jalopy Journal
[ATTACH] Hi Fellas :) I’ve been out of the hamb for a long time but some of you hardcore hambers might remember I did a build thread while doing...
I got this unrestored 409 truck engine for my latest project. [IMG]
Working forward with the support for the rear torsion bars . This is for the backend of the bars . There will also be a 45 degree support from the...
I know it's geeky :) I just ike it as clean as possible . Grinding cold rolled or heat rolled is ok but cast steel is really something else .
A time ago I started the time consuming of cleaning up the block. After lots of grinding I realized how messy the garage turned out so I wait for...
Hese an older picture when I were about to make the motor mouths. I use 2 plates bolted upfront on the block and they rest on top of the frame...
Summertime works for me ;)
They're 1.050's and depending on arm length I be around 380-450. Thinking of making the length adjustable.
Thanks Hasty , I'm glad you appreciate my fabs :) As you says , want the car 3-4 inches lower then my 5w and also get a great travel .
[MEDIA]
Just to get the idea [IMG]
Below is the fab of a member with a bolted lower section supporting rear torsion bars , exhaust system and with a driveshaft ring. The removable...
Separate names with a comma.
The Jalopy Journal
