The Jalopy Journal
I used a lube locker gasket on the 9" in my car. It has survived a couple third member changes so far. It was expensive to start with, but not...
I used the TKO in my 55 with the stock bench seat. I utilized the rear shifter location with the more forward mount. It works great for me, but...
[ATTACH] I received an email today that Mutton Hollow Chevys is still redeeming Danchuk gift cards. I remembered reading this thread and thought...
We purchased a camper last year to take a few trips in, it has greased bearings in it with brakes on all 4 wheels and weighs about 8000# loaded...
I put a TKO600 in my 55 Chevy in 2019. Its the best thing I ever did as far as driving it goes.
[ATTACH] [ATTACH]
Yes. I will snap a better picture. When it was in my 55 you couldn’t see the module without trying to find it. With the way the distributor is...
I had Dave convert an old point distributor for me when I had the 283 in my 55. It is a fantastic piece in my opinion. It did take him a while to...
I was given a SBC fuel pump pushrod a few years back that was longer than stock. It was made for an aftermarket block and I didn’t realize it. My...
I fought with having enough initial timing in the small block in my 55. It has a XR292 solid roller in it. I found a set of bushings that let me...
Do you have to do a lot of tuning changes when changing fuels? Do you run the same boost levels with all the fuels? I have always been...
I have a couple Dana 41s out of CJ3As, located in East Tennessee.
Separate names with a comma.