The Jalopy Journal
I think that's true. I believe the bearing is allowed to float a little laterally so it can align with the clutch if the crank and trans axis are...
Throwout bearing slides on the trans snout so it's movement is already linear. The arm engages the back of the slider where there's nothing to...
I used Eastwoods two part ceramic aerosol and was very favorably impressed. Expensive; about $30/can, but smooth spraying and durable. I'll use it...
There's more trunk space in a body by Fisher.
Put LEDs in them; won't melt.
I used sunbrella canvas (a marine product) over molded plywood but now I'm feeling a strange, and probably sinful, desire for some pegamoid.....
You are really looking for how much they vary, rather than a particular number, so as long as you don't burn up the starter you'll be fine.
You can buzz it out with a meter or even a test light and easily determine what goes where.
Fortunateson... I didn't take pics while building but the black housing is just plywood. The heater core is Ford pickup, copper as I needed to...
[ATTACH] Here's mine, converted to H2O. Blower fits up under the dash and can't be seen. The original Southwind knob controls the 3 speed blower;...
Not entirely correct, pressure does affect the calibration. That's why carbs need to be rejetted for different altitudes or even barometric...
Thermo siphon systems were abandoned for a number of reasons. One of those was their intolerance of even a slightly low water level. If it dropped...
No intake or exhaust on the right bank, so I think it's a 4 cylinder built on a V8 block. Why the plugs on the right?... to confuse onlookers.
Not much of a shoebox fan but that really works.
Black exhaust means it's too rich. It does not mean that you have too much carburation, although you might, or too many throttle plates opening. I...
Separate names with a comma.
The Jalopy Journal