The Jalopy Journal
@Bored&Stroked it's a Studebaker so it's a forged crank.
I'm going to keep getting it. I'm not a big pro street fan but I know not every single issue will be tailored to my taste. It's always been that...
Couple solutions. Tach on the column add a gauge panel where the glovebox door would be or add gauges mounted below dash. Find a badly damaged...
My question is where's the radiator cap?
@squirrel I don't think too many people doubt your identifying ability given your track record.
I got my copy of Hot Rod today too. I also got my copy of Hemmings Classic Car.[ATTACH]
Got my quarterly Hot Rod today too. Pro street is the theme of the issue.
[ATTACH] @Ned Ludd It's not offset any more than stock. If you look closely at the exhaust it's actually very close to the frame rail. The 23 has...
[ATTACH][ATTACH]
You could look for a set of old General Jumbo wheels.[ATTACH]14 inch with 5x5.5 pattern
I would try to make something from tubing and some flat stock that bolted to where the trunk hinges mount going to the taillight area to try and...
@GearheadsQCE the GM 8.5 10 bolt rear would have a 30 spline yoke if I'm not mistaken. Don't know about the plastic slinger.
@The37Kid Bob, there's a whole thread on here about them.
@29Sleeper I'm with Bob, what's the story on that engine?
Same keyway on axles same key and same nut on the end of the axle. That's about all they share.
Separate names with a comma.