Recent Content by sprint3

Post

Awesome! Thank you sir!

Post by: sprint3, Jul 3, 2020 in forum: The Hokey Ass Message Board

Post

Pin is .927 or very close with my cheap azz calipers. From all measurements I am 99.9% sure they are for a .060 over 292 chevy[ATTACH] [ATTACH]

Post by: sprint3, Jul 3, 2020 in forum: The Hokey Ass Message Board

Post

I recently recieved a box of new jahns forged pistons. The box is marked 6-1143H 3 7/8 .060. Does anyone have an idea as to what they might...

Post by: sprint3, Jul 2, 2020 in forum: The Hokey Ass Message Board

Thread

Looking for an isky gear drive setup for sbc. These are 2 gears and run the cam in reverse rotation...

Thread by: sprint3, Mar 11, 2019, 0 replies, in forum: Parts For Sale

Thread

Looking for a set of .030 over sbc 327 pistons. Forged and full floating. I don't care what they are as far as rod length goes, or if dome or flat...

Thread by: sprint3, Mar 10, 2019, 0 replies, in forum: Parts For Sale

Post

Just tore down an older 427 chevy engine...has a roller cam...two markings on the back TP228 and FA7637...I am assuming old trw...but I can not...

Post by: sprint3, May 24, 2017 in forum: The Hokey Ass Message Board

Post

And now I need a sample of an old rear windshield seal so I can try and match it to some universal seal...Anybody?

Post by: sprint3, May 17, 2017 in forum: The Hokey Ass Message Board