The Jalopy Journal
Is the method of "soaking" this the same as mentioned by Accurate Mike? Or will there be specific directions on the container?
I believe it to be fiberglass yes. It is definitely not metal. Im not sure what else it would be?
Thank you for that! Would you have a preference of using the resin, or using the epoxy paint? Ultimately I would like to respray the firewall...
Hey there, I have a fiberglass heater box that is in good shape, but the fiberglass is kind of dry. Its not cracked or broken, and doesnt need...
You could always use a 14014416 head. This is a 305 head with a 58cc chamber, 1.85intake and 1.50 exhaust. You can punch them out to 1.94/1.50 or...
So after a bit of a delay, here is where I am at. I took the lifters apart, put them back together. Didnt find anything unusual. Learned not to...
This is going to be my next step. I know the even number pushrods are blown out, I still need to do the odd side. And thank you for the advice...
So, new drill and a pressure gauge on the front bung. Between 60-80 psi at the front, depending how fast I run the drill. With the intake off, it...
Did the motor sit anywhere for an inordinate amount of time? It wont help your situation, but I am mildly curious. Im sure Summit shipped a good...
Nope. Coming up the distributor tower around the lower bushing of the priming tool. Using an actual SBC distributor body with properly spaced...
That’s exactly what I did with this one. Ground off the teeth, and cut the top of the shaft just below the weights plate.
After Johnny Gee suggested the tool, I compared it to an SBC dizzy and the lower bushing was taller on the tool than on the dizzy. So I cut apart...
No, I did not weld it.
I would have to measure the height on everything. It sits in the slot snug and has almost no wiggle to it. I will measure it against a couple of...
Separate names with a comma.