The Jalopy Journal
Engine is back together! [IMG] [IMG]
Good observations and points made. I don’t want to disparage whoever built the car. There’s some really good things about the car like you said....
Pulled the engine and trans tonight. Went well with the gantry. Plenty to do! [IMG] [IMG] [IMG]
Removed the “console” or whatever the previous owner made... [IMG] Much better. I’m not sure, but I’m thinking I’ll have some sheeetal work to...
Put the car in the air for the first time on the lift this morning. Took a good look around. Lots looks good, plenty of things to address, clean...
I bought this Cold Case radiator setup from Summit. Too many bad reviews on the Champions.. [IMG] [IMG] Little metal work left on the fuel tank...
Made some progress on the trunk floor today. The fuel tank mounting flange is welded in. I did 5/16 holes on 3” ish centers. It went well save for...
Cut the trunk floor for the Mustang tank. First time using my import (Razorweld Vipercut 30) plasma cutter. Worked a treat. [IMG] Exhaust...
Clutch parts arrived today. Got the Centerforce pressure plate on Amazon for less than half of what everyone else was charging. Disc is 1" 14...
It involved about 500 miles of windshield time, and I came home with a 84 V6 Camaro T5 and bellhousing. I have the Walton Fab pedals with...
It’s 1.5 x 1.5 x 1/8 angle. I plan to cut a hole in the trunk floor, punch holes in the floor around the perimeter and plug weld from below. Then...
Got the fuel tank mounting ring made tonight. [IMG] [IMG] It was a great opportunity to use my welding table. [IMG] I’m still trying to...
Simple mdf template to help layout the Mustang tank location. Had to replace my sewer line at the shop, so ‘54 patiently waits. [IMG]
I did check with them. Hoping to find a solution.. I may have to make my own adapter.
As the subject says, I'm trying to figure out if Advance Adapters 712548 bellhousing will mount a '96 Camaro WC T5 (1352-247) to a '66 327. I want...
Separate names with a comma.