The Jalopy Journal
Here's where I'm at now, I dropped the trans and cut about 1/2" off the tip of the input shaft and retappered. (It was scuffed and could tell it...
That I did not do. Months ago I had to get a new bell housing so I could get a starter that bolts to that (cuz they don't make a starter that...
Clutch is the width of the surface of the pressure plate, it doesn't stick out to get snagged by the bolts. It's a diaphram pressure plate. I'm...
peadl feels likt it would normally, not real hard.
I thought that too, but the alignment tool and the trans went and out like butter. I went to the local clutch shop with the flywheel, bellhousing...
I have a "59 Chevy Apache that I dropped a "63 283 and a "90's S-10 5spd behind it. New everything between the engine and trans. Doesn't matter...
Hey yall, new to the forums. Read through the forums before, now finally signed in and ready to start discussin'.
Separate names with a comma.
The Jalopy Journal
