The Jalopy Journal
Is that to whiten the whitewalls or is it to 'dress' the tyres as per my earlier post?
Does anybody use (recommend?) a dressing to use on tyres after the whitewalls have been scrubbed clean? ie to keep the white looking white and the...
And the loss of fluid (or lack of loss) from the master cylinders would show where the problem was.
Very handy, thanks for posting it!
Man that info will be real handy if I ever have to do a similar job on my '66 Town Landau!
16mpg with by 8BA F1 on a good day. But then again we use Imperial Gallons (Until litres took over)
If it was my manifold I would check the front water runner area for signs of similar corrosion inside the runner area.
Damn right! An aweful sacrifice by those guys, great ANZAC service here this morning in memory of them.
Not very often that any convert their cars to right hand drive, we just get used to the steering wheel being on the left - and depend on a...
Just about jumped out of my skin at that scene!
In my case I used Copperkote (I think that's how it is spelled), I use it on all exhaust bolts.
Bottom bucket was built in the 70's in New Zealand, notice the steering wheel on the right. Not sure if the bucket is still here in NZ or still on...
It was more that it's curious the broken ones were adjacent to the exhaust riser on each side, Ive owned a scad of Y-blocks but never seen...
Hmm, exhaust valves near the centre on each side..unusual. Do all the rockers move freely? When you primed the motor did you see oil coming out...
Just be aware that a higher pressure cap doesn't make the engine run any cooler - it just means the motor can run hotter before it boils. And...
Separate names with a comma.