The Jalopy Journal
Great info! I just got another 49-53 Flathead that was pulled from a ‘40 Ford to do a Y-Block swap. This Flathead appears to have been rebuilt...
I have a question that I hope you guys/gals may be able to answer for me...I am in the process of upgrading the wiring in my truck, by adding a...
I am currently working on a 1960 F100 with a straight 6, 4 speed trans. I am looking at swapping a 292 Y-block into it and have found out that I...
[IMG][IMG] Sent from my SM-G930V using The H.A.M.B. mobile app
No...hadn't thought of that, but know I am thinking about that too...thanks Sent from my SM-G930V using The H.A.M.B. mobile app
[IMG] Sent from my SM-G930V using The H.A.M.B. mobile app
It's alive! After we lowered the clutch MC and the attachment point in the bottom of the pedal, we increased the throw of the MC by over an inch...
First...thank you for all the suggestions and areas to check. I am going to try a few things tomorrow, minimize any slop.in the linkage going...
Because I am using the early truck "hogshead" bell housing, I actually do have the inspection plate....I can see everything moving and engaging...
I am using a stock Flathead throwout bearing, stock 10" pressure plate and 10" clutch disk. All brand new...I have approx. 1" of play before the...
The MC is a cheap one, my ignorance as a beginner builder, and I have thought that might be the issue too....wasn't sure if that made sense or not...
How I found my Model T - 1
How I found my Model T - 2
Separate names with a comma.