The Jalopy Journal
I lost an engine because of those bits, when the shop rebuilt my heads they installed those seals on the tapered guides that originally had...
The cfm is rated at different vacuum depressions between 2 bbl and 4 bbl. Divide the cfm of your two barrels by 1.414 to convert.
Be aware that the 1-1/8 shaft is a mid year change in 67 as well
I believe it is a 9-3/8", fits in a standard 9" housing, came in some large cars and trucks iirc.
The Shelby box is octagonal and has COBRA cast into the lid
Same thing when I was kid, used the Oly beer opener to punch triangular holes in both sides then pour in a funnel. Funny thing is when I cleaned...
On a road racer, check if it is cambered as well.
oops: 278 advertized, 240@.050, .480 lift, 108 lobe seperation
The engine is a 350, 10:1 compression, 2g 3x2. The vehicle is a bare bones 36 Ford truck with a 5 speed, 3.70 rear end, and 29" tire. I havn't...
keep the big truck fenders, they can be used for patch panels for the pick up fenders.
The one I have seen mentioned on the HAMB is Alodine 1201, available in small quantities from Aircraft Spruce.
I'm putting a 350 sbc in a 36 ford truck, full fendered but otherwise bare bones. The engine is rebuilt .040 over, balanced, with 10:1 pistons,...
Separate names with a comma.