The Jalopy Journal
Knoxville dragway
You got it right when you said "true Car Guys" there are still a few left.
Try buying a few cobalt drill bits, that is all we use in the shop. They hold a good sharp edge for a long time. Cutting oil also helps. Motor oil...
Is this a flux core wire welder and you are trying to use regular mig wire with no gas?
Anything at all except Rebel!.
You read it wrong, go back and read the whole paragraph. :D
If you are wanting to build a rat rod then go with steel, if you want a nice painted T then glass is the way to go. Rust, I don't think you can...
You can buy J bends and U bends from a lot of different places. They go along way, to building a set. Speedway, Jegs, Summit just to name a few....
You can do that with a Vega box, mounted under the frame. we do it all the time on Ts and Model A. We even keep the brackets to do it with....
EZ Wire for sure. We used to be a Rebel dealer, but we won't go there!
I'd be for checking the timing and making sure the vacuum advance is working like it should.
Good luck with the Post Office. Too much red tape with them. From past experience, you will probably never get your money. We never did. We only...
We have the standard T Bucket body for just $399.00 and turtle decks for just $299.00 and the lid opens on the turtle deck....
1" is all we use on our radius rods. We use a .219" wall DOM. Seen way too many .156" rods fail, always on the rear end. Here is a pic of a set we...
I graduated high school in 1968 and went to work in a NAPA machine shop. The labor rate was $6.00 per hour. Prices for engine work were really...
Separate names with a comma.