The Jalopy Journal
https://forums.aaca.org/topic/285543-pickup-truck-conversion-1951-chrysler-imperial/ Could be neat, but again only if OP can finish the job....
On #1, agree. Redo the patch. On #2, I'd wipe down/flood the seam with rust converter before priming. Your call on blasting to prep, but I hate...
A conversion from 4 door to 2 door will take more effort than getting a 2 door. That's IF you finish the job. If you get stuck in project limbo,...
Tim, since it seems like you are about at that point, I'll mention a tip I read somewhere a while ago. To make a trans tunnel in a tight car...
from the sidelines, my guess on modern longevity dropping is two-fold; getting the engines up to temp ASAP and running them on the edge temp-wise...
I would imagine that most 1900-1940 engines that were bad aren't even in the dusty attics of members' minds. There were a number of obscure...
While I thoroughly enjoy the progress and plans for the future, it's going to be a sad day when the A chassis is set aside for the update. Time...
Yes, that was another step in the progression toward mediocrity in automotive magazines, the template for listing the products used to build the...
Check the local hardware or glass shop. A sheet is pretty cheap and saves that vintage window. Check the reflection once it's on the bench for...
I would at least draw file those, using dychem or sharpie to guide me and check with a straightedge. You don't have to get everything perfect, but...
After work and inspection, ALWAYS do a through cleaning. Got bit by a fresh crank that was 'ready to install '. Had junk in the oil passages. Did...
You can try raising the rear some with a jack in the driveway, but that Ford is lowered in the rear too. The Plymouth frame has a big dip in the...
You got all the good guys input already for the question. As always, Gene has a bunch of information. I have nothing more to add on HOW to lower...
many thanks! GM part L4535 , 6 Volt, part number 444279 his is not a sealed beam, rather a riveted bulb and reflector. the glass is separate...
got the bulb end all figured out, but couldn't source a bulb today. my friend has a firm grasp of the procedure to replace and will swap once he...
Separate names with a comma.