The Jalopy Journal
Following is a link to Racing junk..com for my machine shop equipment that I want to sell , it is all in very good condition, and operable. These...
I have no idea of your mechanical skills and will not pass judgement if you are not in a position to pull the engine. I was in the custom engine...
I do remember a FED shown in Hot Rod in the late 50's / Early 60's with a Packard engine. right now I am in the process of putting my Hot Rod Mag...
I had a 1962 MGA in the ea5rly 70's (Still love that model) that had a factory hand crank and on numerous occasions I would start that sucker with...
You can get fuel cell foam that will stand up to alcohol. I used 25% methanol carburetors on oval track engines and with the alcohol foam and BUNA...
I have a very well tooled Winona PH2000 valve sear and guide machine, these units have an air float table that rolls and also can be set ti do...
I neglected to mention that on the standard everyday street heads we would use the ball broaches to get the clearance, they also tighten the fit...
I installed literally thousands of K- Line or the equivalent liners since the mid 80's and if there was a quality issue or a shop said they were a...
Check that lifter bore and make sure that the lifter moves freely not only up & down but is able to spin. Id there are ant burrs etc that impedes...
The dowels are absolutely necessary on not only the 302 but any engine that has them. They are available, do an internet search for Ford 302...
You can have mine, I can't afford her "rent" any more
Separate names with a comma.