The Jalopy Journal
Thanks guys, you have been very helpful!
I have built an A with a totally stock 260 horse GM crate engine with 2 Demon 2 barrels. It has a 350 trans and a 3.73 rear end. Do you guys...
bob t! I think you may be onto something with the 3.5 lbs. The tech support is a place called Allstate Carbs up in Jersey. He has told me that...
bmp
A follow up on the prob. Called Mallory and they advised me that the dual point needed a ballast resistor with 1.4 ohms and a coil with 1.5 ohms....
Does anyone have any experience with Demon 98 2 bbls? Seem to be rich but Demon tech said my 7psi fuel pump is ok, also he said screw down the...
Thanks very much guys, this ought to keep me busy tomorrow a.m.
Jim, would you jump as I said from the bat pole to the ign pole on the back of switch or would you disregard switch and wire around it?
Yes, Jim, that's how I have it. What do you think regarding the switch being junk as mentioned above?
I have been wondering about the switch too Trolls "T". Wonder if I jumped from the power pole to the ign pole then tried to start it---do you...
I did Jim. This is the first points ign I've used in years and I can't remember if there is a power in and power out side for the ballast. No...
Separate names with a comma.
The Jalopy Journal