The Jalopy Journal
Currently parked in dry dock...
Ditched the floor, there was too much rot to repair. Here is the body just sitting on the frame before the rail ends are cut off.
Decided this deep into it to replace the firewall, here it is installed.
Project updates: Found second left tail light patch panel to finish off the terrible tail light crater holes that were there before. Starting to...
Yes, please post some pictures, I would like to see how your build is going.
Gutted the entire trunk floor all the way to the back seats, was hacked in poorly and not properly tied in; just kind of floating in space without...
New right side tail light patch panel installed.
Started on some sheet metal work; removed the poor fill/weld job on the gas filler hole found after dipping the car. Going to relocate it to the...
I didn't want to blow the bank account up with air bags, so I opted to go with some drop spindles to bring the car down. I went with RideTech's...
Wes, here is a drawing of the frame I found on the internet off of a G-body forum. The drawing indicates the structural bracing that is...
Here is the new shortened frame sand blasted and primed that I did get done this spring.
Wes, I've be on hiatus from the project but getting back into the swing of things now that spring is here.:D The only gauge for car height is...
Body work progress also. Cut off the right rear fender that was poorly welded on. Will re-weld it back on in the correct place, since it was out...
Separate names with a comma.