The Jalopy Journal
I'm pretty sure L R and S series mounts are all the same. I have my bed off currently would you like me to measure it or frame holes?
I find that before one uses the wheel they should learn to rough into a shot bag and hand shrink with a tuck tool. After you have mastered these...
Sadly I didn't take a lot of pic's while building, hard to hold torch and camera at same time. It's just a bellybutton chevy in it. I'm surprised...
Ooops! I mean L or R model
I like the look and stance of your binder. Are your doors factory? In the states those would be off of an L or S model
Don't know if you are interested but someone was re-poping ih caps and selling them through oldihc.org website.
Larry's license plates in BLUE Springs is close to you he hits our local swap meet every year, have had good luck with him. He's an ex-patrolman...
I've got one shoot me a pm with your needs. I've been looking for someone that had one to compare notes.
I've had pretty good luck with shapiro but I bet you'll end up with more than just steel if you look around.
In the mid eighties a friend and I went to Ozark Raceway to see the new pavement being put on the track surfaces. We walked the track and ended up...
Very nice! It'll be around long after the asian crap is returned to them as scrap.
I have the article in the hot rod paperback book Hot Rod chasis construction and it's copyright is 1967. I think the King chasis article on here...
I know times are tight but I think they were dirt cheap through lindsay books last I checked. If I was interested giving them away I bet shipping...
That ought to stiffen it up for our fine Missouri roads and without KCIR thats where the action gonna happen.
Check out ron reils propane burner website lots of good info for the do it yourselfer there.
Separate names with a comma.
The Jalopy Journal