The Jalopy Journal
About half of the old Oak Hill Drag strip is still almost visible if you know where to look. The entrance to it was roughly where Williamson creek...
It appears to have the "Truck" oil filter block on it so I would say it would be either a 360 or a 390? If it is just going to be a cruiser and...
Can anyone tell me what the torque number is to crush a pinion sleeve on a 9" ford. I have the pre-load inch pound value but can't find anything...
I use the Hobby Air shown in the post above, one of the best items I have purchased! I use it for painting, sand blasting, chemical stripping and...
From the photos it appears that for some reason the idler arm is to low causing that end to hang lower than it should? The center link should be...
When you use a crimp type connector then solder the joint you are inviting a problem unless you also use the shrink wrap. Using the shrink wrap...
Is there a cheap and easy software out there that allows you to draw a wire diagram? Scott...
I have found that because of really nasty fumes associated with the POR-15 I only use it where I need something the run or seep into an...
They ran the races there with the finish line toward 1325 and even back in the day several cars made it either into the right of way or over 1325...
Those were also used as the "feet" for trench or tunneling jacks.
Any 60 trunk pan should fit, Starliner, Sunliner, Galaxie, 2door, 4 Door, Fairlanes and even Mercury and Edsels. The Galaxies with the flat short...
Best scenery out West of Austin. Best land prices are southeast of the city. If your business needs to be close to the city downtown area you can...
By taking the 1 1/2" out of the center, didn't that change the point that the rack centers on the pinion? Wouldn't that make it have more travel...
I have been thinking about the uni-steer for my Starliner but have been told the they do not allow you to turn as sharp as with the steering box...
Separate names with a comma.