The Jalopy Journal
Jerkoff still owes me $250. I loved my $300 painjob that cost me $600 in repairs and pealed off in 3 months. They painted my radiator to...
If I can get the new radiator in tonight and the shroud built I think this would be a nice test drive. Damn Summit gets my money every time I'm...
Just pull the axle shaft. When you do if it tapers from the wheel bearing area to the shaft then no. If its a straight shaft then yes.
One way to keep it a bit lower may be to use a 2WD tranny and a divorced T-case. Then you can move it back and use longer driveshafts with less...
My 53 Bel Air has a 1968 Camaro 10 bolt rear in it.
I'll be watching Reno. If they are dumb enough to show up to Hot August Nights that is. Only the dumb ones get caught as they say :mad: I feel...
Took it out for a test drive to the next town. It was 100F outside and I did start to overheat. While at idle it was slowly raising and on the...
From what you post basicly any full float rear. If this is for your truck why do you need them cut down? A D60 rear can be had for $50-100 and...
Good ideas! I'll try the angle a bit first and I think it does have a stamped lip on the back if I remember correctly. Thanks guys
O yeah put in a PowerMAXX starter the other night since the OEM ate the teeth. nice light starter and cranks nice but quiet.
Off the shelf backing that I bought with the gauges from E-gay. The seller is EZ wiring but they go by oldschoolparts or something. Great to buy...
Exactly!
Wow I've called 5 times, left voicemail, and an E-mail with zero response. Kit was great but the instructions for the 21 circuit is the same as...
Thanks for the links. I have an E-mail in to see if they can get me those oversized. I have a local fastener place that can but I don't really...
Bump. Anybody?
Separate names with a comma.