The Jalopy Journal
I'm thinking of starting another project and am looking for your input. I've seen dual Wico mag set-ups for the flathead ford V-8 in both a V...
Yes, just about any part you need for Wico's, you can get at www.standardmagneto.com
Just wanted to show-off a 6 cylinder Wico magneto I built a new base for to run on a 223 ford inline. It was originally used on a tractor....
I'm not sure if there the same but I bet somone here could verify it.
I finally got the T5 into my F100 this weekend and it runs great! The first time I put the tranny up I found it needed to be about 3/8" closer to...
I just finished putting a T5 in my '64 f100 and now want to hook up the speedometer. Two questions. One, where could I get a mechanical speedo...
Thanks for all the good advice!
Whats the best way to install a new, press-fit, ring gear on a ford flywheel? -Thanks
Hopefully looking down from above (or up from below) on a huge family fight over who gets what!
The shaft is long enough, but a new pilot bushing is needed. Its behind a 223-6.
Heres some pics of my modified bellhousing I just finished. I'm putting a Borg-Warner T5 in my '64 F100. Lower two bolt holes already lined up....
Separate names with a comma.