The Jalopy Journal
I managed to score a Sun 506, along with the cabinet. It has a xenon bulb, and will spin a dizzy 6000 rpm. The bulb was burnt out, and some...
Most of my stuff is OT cars, circa 60s and 70s. It's rare that any parts store in town has what I need. The last time I looked for anything was...
A good read from a jeep site, jeeps and AMC seem to use whatever they could, and often cross bread parts...
The HEI was the worst main stay factory electronic ignition system from the big 3. Why put your module so close to your high kv coil?! Why is...
I worked at a few parts stores in my younger years as the big chains were just getting into my area. I worked at those stores... Flat out they...
I've been doing some research, and I haven't really found any correct answers. I'm looking at finding some Ansen Slot rims. What I am looking at...
390s can run good if the right guy is building them. We've got a local guy at the track with a 390 in a mustang that runs low 7s high 6s in the...
How about had a good motor and never used it? Two buddies I know that rent a shop together both had this happen at the same time. I built a 460...
Back when I was in college working at a chain parts store we had an analog starter/alternator tester, the one with gauges. After doing some...
Oh use a little spray bottle when the engine is idling and squirt the headers on both sides and tell us what cylinders are cold
Spark plug air fitting can be found at the auto parts store pretty cheap. A vacuum gauge should tell you if you have a loss in vacuum at whenever...
yup sounds like vac leak somewhere. You could do a leakdown test to rule out bad cylinders, you'll be listening for air exiting through the crank...
Are you running the torker, or the torker II? The torker II isn't worth the aluminum it was cast with. The original torker was decent for...
[IMG] Sometime in the 30's Title: Gunder Rust's snowmobile near Alkobo N.D. <table border="0" cellpadding="1" cellspacing="0"...
Separate names with a comma.