The Jalopy Journal
Its not close to the frame, it’s at almost the same level as the frame
the point was I didn’t want to run AN/steel braided caliper hoses though. Id Like to run the standard rubber hose
I can’t go under the frame, my wishbones would hit the line, I already have it on top right now and really don’t like the look. Only other option...
So I’m running gm metric front calipers, rubber hose and boxed stock frame I can’t seem to figure out what I need for through the frame fittings,...
I think the next step is to take the side over off yes. I agree it seems like it has what it needs to run!
Didn’t want to ask,as I feel I’ve checked everything but I can’t figure it out so here goes. 1930 stock bottom end banger motor. Bought this car...
I havnt seen it around here, there’s a fire sprinkler company the next town over that I could maybe try,they have pipes for buildings fire system...
that one I found being 5 thou clearance, I’m guessing you’d probably be right. Good point
nope
https://rover.ebay.com/rover/0/0/0?mpre=https%3A%2F%2Fwww.ebay.com%2Fulk%2Fitm%2F200973599013 Might go with this
that right there is actually perfect, but at 10$ for 3” and then shipping. That’s a lot for 2 motors worth
got a link? I’ve been searching high and low on ebay with not much results all I’ve found so far is 0.125 wall. I’d like a little thicker
well sort off. But that top one you pictured,is the tube part I want it will be welded on the frame with some pieces, and it will slide into the...
Separate names with a comma.
The Jalopy Journal