The Jalopy Journal
You got it, hope it helps give some direction on how you want to mount yours.
Finished up the center console project on my Merc Project.
[ATTACH] [ATTACH]Got after it today in the garage and finished the center console. I made it out of 1" round tube framing and skinned it in 16 and...
The last pic I am pointing at the bottom of the seat where the tube "stop" will lock up against when you push the seat down into place
[ATTACH]I am pointing with my thumb and index finger at the tube I used to locate and lock the seat bottom in place which is similar to how the T...
Another view of the Skeleton and bracing
[ATTACH]You can see the front "stop" which supports the bottom of the seat closest to the bottom of this picture.
Hey ZZ Top, This is how I did mine. I made a Skeleton out of 1" Square Tubing, here is the bracing for the center of the bottom of the seat.
[ATTACH]A side view of the arm rest in place skinned in Sheetmetal from the passenger side. I have left 1/2" of space to allow for foam and...
[ATTACH]Here is the start of the arm rest made out of 1/2" round tube. It will be covered in Sheetmetal and setup for padding in the upholstery.
[ATTACH]Here is a side view from passenger side
[ATTACH]Here is the start of my custom center console. I am building it of a combination of round tubing, square tubing, Sheetmetal and wood. This...
Hi Cheater Chrome,
Thanks for the good words here, this has been a long, tedious and educational project that I embarked on several years ago but...
Rear T Bird Seat in placement and just starting the woodwork for the interior upholstery panels. Note the "Drive In Speaker Cover" which...
Separate names with a comma.