The Jalopy Journal
Had a 64 Bonneville that had a under dash unit that worked really good. But I guess when it's a 100 degrees outside any a/c is better than no...
Sounds like wheels are locking against the calipers or pushing the calipers tight against the brake disc. Tighten up the wheel then slide your...
Mini portable English wheel... ...
I agree with above, without a compression test, leak down test and known oil pressure to me I'd value it as a flip of the coin motor and honestly...
IF it's going to be replaced and it's a junk piece I take a 4" cutting disc and cut a deep slot on the back side of the pitman arm, straight...
What started out as a 38' ford dash panel, mix in 35 to 40 hours labor and I ended up with this. The gauge panel comes out from the back side...
The lathe, gun safe, gauges and panel hanging from the ceiling would be my first grabs. Then the bench grinders, vises next, then whatever else...
I'm sorry to hear about your condition but I also want to say I think what you are offering is amazing ! I hope things turn out better than...
Hemi, it's a hot rod.... ...
As cheap as some shops charge for balancing I couldn't imagine wasting time to do it with a bubble balancer. With newer equipment it also does...
Pics would help alot. If it's tack welded in at the edge of the center I'd take a 4" grinder, put 2 cutting disks on it making it 1/8" to 3/16"...
I'd just fade the body line out in the door just before the door handle. ...
Let's see....uhm.... Joe has the body....? Marty has the clone chassis.....?.... Could this be a match made in heaven? One of those "hey you...
With the looks and vibe of the car right now I'd do the small things, nose and deck, shave the door handles, drop the nose a little. Go back with...
A lot of cool touches on that car, not something I'd build but my Hat off to the guy that did ! He had an idea and went with it and finished it. ..
Separate names with a comma.