The Jalopy Journal
I will try to post a picture of one after the holidays, my friend is restoring a 29.
Very nice tech, and for those that worry about such things, if the weld was ever to break you would only loose the right side tie rod control and...
I found this and it looks like its priced right! I don't have the energy to chase it though....
Ok, let's start over. Make plugs for both master cyl connections, bleed them and attain a solid, and I mean solid pedal. Than connect the rear,...
Hey...I think I should weigh in here, after 30 years fixin cars for a living and paying young and old good wages to work for me I've learned some...
2 94's with one power valve, but stagger the linkage slightly, (open one slightly earlier than the other) makes it much easier to drive! Gets...
Free oil furnace.....700 gallons of free oil too. Got hooked up with an oil distributor and when someone installs a heat pump I get all that bad...
5 bolt 289 blocks are getting scarce, wish ihad a few as trading stock.....just sayin.
I would love to see the calculations needed for this.....seems there wasn't enough info in the request too. Thanks, knowledge is king!
Many facts in this thread, I'll ad some words,you sort it out. True, stiff in front means push, stiff in back means loose, however there is roll...
I worked on that modified and the narrow mount makes for a lighter spring rate, the wider the mounting the shorter the effective spring and the...
Hmmm, have parrots rockwell tested before you reassemble, it looks like it was spinning so lifter bore is likely not mis bored......sure fire cure...
Having recently completed same vehicle sans wood I can say replacing the wood with steel tubing, opening up the nail holes and plug welding the...
Separate names with a comma.