The Jalopy Journal
I'm rebuilding my '28 model A sedan with a '32 grill shell and want to run a full 4 piece hood. I've found an outfit that makes a 1 piece solid...
A lot of nice cars. Lots of guys driving their cars even though they aren't finished yet. It shows dedication. I guess they are still saving up...
I don't know what the ones that come with the R&P are made like. On the trucks it is a rather coarse splined shaft. The thought has occurred to me...
I know this is an old thread but I'm considering this R&P on straight axle setup and I don't quite get the concern about the a slip joint in a...
I did some searching for the GM 525 box and it does look like it might work (if I'm understanding what I'm seeing). It appears like it can be...
Not yet. However, I have decided that I will do as suggested earlier and strip the front clip off of the truck (I need to paint and detail the...
Thanks for all the input. The headers I have are sanderson block huggers. I have the original manifolds if I have to use them but would rather use...
I hear ya. However, The truck is pretty much done other than an engine swap and the engine is also detailed and has ceramic coated headers and I...
I am going to be putting a 348 into a '57 chevy 3100 pick-up. I'm told that the steering box interferes with the exhaust. Does anybody know how...
Thanks for the reply. It's a repo firewall. I was able to get it to fit by cutting out the braces in behind the firewall and pushing it back about...
I'm installing a firewall into my 28 model A and it APPEARS that the bottom section is about 1/4" too wide. When I put it in and clamp it into...
I think the music and/or movie association and popularity feed off of each other (same with the "deuce"). They are in songs and movies because...
Separate names with a comma.