The Jalopy Journal
I will try that what could it hurt thanks
only one stuck #1 and tried marvel a few times on it not giving much also tried transmission fluid pb blaster wd 40 gel hot water, coke kinda...
Bump
update I tried CLR in # 1 cylinder it appeared as rust but when I went to scrub it it was almost plastic like substance the CLR and a plastic...
Awesome collection glad to see someone save and appreciate them .
I will check it out tomorrow and let you know
started reaming ridges today they are not deep but they are there , also they are much closer to the end of bore than I am used to and dome of...
measured bore with caliper several times since my caliper is not too high tech got 3-5/16ths
block not relieved fooled me till I looked closer both areas around valves are tapered toward the cylinder they are not ground through .
Nice pic is a little dark but the snow makes good contrast . where are you located .
Having a hard time finding pictures of wrapped springs anyone have one to share ?
got the crank and pistons moving coke and pepsi worked great I wouldn't have believed it . crank is definitely 4" stroke I will measure pistons...
Will do I have been taking it slow found out the crank Marked 1CM is a mercury 4" stroke going to start pulling pistons tomorrow.
springs are wrapped in pieces of metal tack welded together . front and back .
Separate names with a comma.