The Jalopy Journal
Thanks for all replies
I get it. When I built my flathead I had intended to put it in a 31 p/u that I had parts for. Once I invested the money in the motor I wasn't as...
ideally this is a great engine for your build. 52 would be an 8BA and features the largest bore for the flatly as well as insert bearings. The 8ba...
Getting ready to assemble a 32 chassis with a banjo rear. Would like to eventually install a quick change center like the one from rodsville. My...
Never had any dealings with him. When I built my flathead I ordered some hard parts from Mike at H&H and had a good experience.
Thanks for all the replies. My gut told me they were toast the moment I saw them. The more I look the more cracked they get. These won't see the...
The holes are for the lugs and have been stressed from overtightning and age/use. Is this a major issue?
[ATTACH]
They are Early Ford Steel wheels.
Just got some 16x 4 wheels for the front end of my project. After sandblasting I have found hairline cracks on the backside of the lug nut holes....
I'll take 5 of those 97's. My intake cost has increased 5x...the Stromberg 22x.
Does this require any mods to the input shaft. Is the diameter right for throw out bearing? Thanks
Separate names with a comma.