The Jalopy Journal
Hello, have a '36 Chevy 1/2 ton pickup project just about ready to fire and run for 1st time. I believe it would be considered a "resto-mod" as...
Hi, a little late to the party :-) but wondering if you know anything about The Wheel Shoppe now in 2017? I just found this thread and tried to...
Ok, really lame question...I received one of these wishbone ball cap kits with purchase of a Tardel "K-member". I'm using a '32 wishbone on '31...
Beautiful job! Care to share how you acheived such great results? Did you make a vertical cut per Tardel or an angle? What shapes did you use...
It actually has 7 leaves - one of the short plates below main leaf is tapered on ends like all other leaves above. However, the bottom-most short...
2935... Top or bottom of crossmember? The top of mine is 10-1/2" above banjo - bottom space about 8" If I could somehow gain (lose) 3-4", I...
[ATTACH] [ATTACH] [ATTACH] I'm conflicted about whether to "Z" or not to "Z"...prefer NOT, but the rear on my '31 roadster is quite a bit higher...
Hi, currently working on 2 retirement projects ('36 Chevy pickup and '31 Ford Roadster, traditional hot rod). I had hoped to purchase a Mig...
"Shameless plug- I make and sell weld on flanges for F1 and F100 boxes to be mounted in deuce and A frames" Hi, old thread, but i just acquired a...
It's almost a year after Vernon's post but I just called him about the '28 parts. Unfortunately, he sold them already, but said the fellow was...
Thanks a ton for your replies - very much appreciated. I passed on the back seat because of the wide front - but sounds like you made it work...
Hi again - I had kept a photo of your cab interior with this note about the seat you used. Returning home today, found my neighbor had put her...
@merles_garage... hi, I'm doing the same and just saw your old post. Did you ever get additional feedback? Would you mind sharing what you did...
Separate names with a comma.