The Jalopy Journal
Yup, as redo 32 says, 37-38 Nash Lafayette..
Pictures, we need pictures..
As rockable says, and I'll add, do it with the trunk fully open..
Looks like a clutch head screw to me..
I know that tip you've got is slightly different from an ordinary welding tip, but I would say it should be the same when lighting it up,, This is...
And another one..[ATTACH]
That ''skip'' you talk about is the faulty (leaking head gasket) cylinder, and when it evens out, is when the coolant has been spat out, and the...
Well I stand corrected, Learn something new every day, thanks for the info 29A-V8..
29A-V8, In all the manual boxes I have overhauled (GM, Ford, and Packard to name a few) I have never seen the thrust washer lock tabs keyed in to...
Is it a modern factory tank unit? these have the pump, gauge, surge bowl all included, or an aftermarket pump only? The factory electric fuel pump...
Never done one, but if it's glued like you think, maybe a bit of heat on the inside will allow it to move??
Hey Rough 54, I'll probably get flamed for saying this.. Note... Replacing new gear sets require the correct specs/torques.. But on used diffs,...
Looks like a Plymouth badge on the rack of the roll over car..
Bit hard to tell, but is the transmission hitting the X member, or does it clear?? If it clears, and everything else is good (angles, speedo drive...
Did the diff have a disc brake setup in its previous life?? That bracket looks a lot like a sliding mount for a disc brake caliper... Buuuuttt,...
Separate names with a comma.