The Jalopy Journal
I have never seen the circuit breaker reset fast enough to cause headlights to strobe. Are the actually going completely off then on or are they...
Cadillac and Imperial had them.
Back in the early 70' s we were heading back to SoCal after visiting relatives in Indy. Going thru Missouri at a gas stop this old early 60' s...
Hobby Lobby carries styrene in different sizes, shapes and sheets that can be used to make that grill portion. 39 Chevy made into a 40 using bits...
The title of this thread made me hesitate before looking......
148.10 is a nice round number.
Looks like you could go 1" larger diameter of a fan and go into the shroud by 1/2".
Corvettes had a larger generator pulley. We used to put them on alternators to help keep belts in place. I think they are still available.
Sounds like a full time shop helper just became available..... ☺
Same as any other race car...
All that works into gear ratio selection. The rest you sort out thru tuning,...
The uneven spacing also reduces cavitation, a point where the fan stops moving air at certain speeds.
This is not a stop light switch. It is a warning light switch in case there is a pressure difference in the system usually caused by a leak.
You need to read the forum rules. The blue Ford is off topic here as well as your other thread.
If everything is coated in lubraplate that is probably the problem. It tends to dry out a bit and will glue a motor together.
Separate names with a comma.