The Jalopy Journal
I have seen one minor fire that resulted from the battery or charger and have read about a lot of others. I have seen others reported where the...
[ATTACH] [ATTACH] Finally getting a chance to get back to the tank. I made a tool that has a larger head on it and that I could bend to get it to...
I see a smooth one for a 4.5” grinder available on Amazon. Any experience with that type? And would it help with the low area?
So you would start by shrinking the area next to the bump first? The low area?
The petcock is off center from the dent and is not very big. I may be able to clamp the rod in a vice and set the tank on top but its tough to...
Oh I definitely respect the chance it could explode and would clean it out prior to heating it up. In my younger years we routinely soldered small...
It’s a pretty old tank that hasn’t had gas in it for a long time. Not to mention it’s sorta rusty inside. So I am planning on cleaning it out.
I feel like it’s just going to push the area back down. There is not a good way to support the back area while tapping on the outside. That’s why...
Pic[ATTACH] The area that is bare steel is the area that is raised. The area around it is still low, but not sure if I should continue pushing it...
[ATTACH] [ATTACH] Pics
[ATTACH] [ATTACH] Pic
[ATTACH] Pic of what I started with.
I am working on this old fuel tank for a project and want to work out this large dent. It happens that the dent is in the area above the petcock,...
It looks to be made of Grafoil which i believe you only install dry. The graphite bonds well to the machined surface and generally can not be...
Separate names with a comma.
The Jalopy Journal