The Jalopy Journal
if anyone knows the oil capacity of a 52 Mercury flathead with this oil pan I would appreciate the information. Thank you. see link to Vanpelt's...
Its not everybody thing, but for me it is an education with out cutting up a real classic vehicle. Unless you are into dual wheel farm trucks I...
I haven't updated for a while. lets see if this will let me.
very nice!
I like it.
update.[ATTACH]
Well ,that is sort of a possibility. I assume the OP knows the sequence to setting valves. If that isn't done right you will definitely get...
Seems to me if you didn't remove the cam or lifters, they shouldn't have bled down. Removing and installing the push rods shouldn't cause the...
Try having someone crank the starter while the engine is being primed. Bump the starter, or use a socket on the crank pulley bolt.
Interesting. I forgot about the centre bolt versions. I was always hunting the early 70's truck blocks. I didn't realize they had different deck...
I have two part numbers for the intermediate shaft. The 64-67 Nova 2 used a different shaft. Apparently it is shorter. Chevy PN3790872. Nova 2...
It's been a long time but I think this is the shaft I used to use. It's been so long since I've been inside a small block. Seems to me this one...
"Removed the shaft from my primer dist., seated it's tang in the slot and measured length at the manifold. It's a 1/4 inch longer than either of...
Are you using a electric oil pressure gauge? I used to use a sending unit mounted at the top of the block under the distributor. I'm wondering if...
Look at the gear set up to make sure it is turning the pump in the correct direction. I'm recalling reverse set ups from the recess of my old...
Separate names with a comma.