The Jalopy Journal
A few memories of Gerb. to start with, Casper. Road Angles club meetings and filling the Majestic theater with smoke. The seat belt campaign....
[IMG] [IMG] TR3 with GM 10 bolt rear end. Not H.A.M.B. friendly but is underslung. Greg Sent from my iPhone using H.A.M.B.
Just simply wonderful. Thank you. Greg Sent from my iPhone using H.A.M.B.
Great story and video. Is there any video with engine sound or did I miss it somewhere? Greg Sent from my iPhone using H.A.M.B.
Well this one wasn’t built with a VISA card and a Summit catalog. Good on you guys! Greg Sent from my iPhone using H.A.M.B.
My 3C IDA Weber’s do this. I pull the tops off and clean the orange sediment from the float bowls and it’s good till next time. Now that I have...
Yes. The finish is fluted and can be sanded out easily. The rotary table is used for a curved core. Sent from my iPhone using H.A.M.B.
Core box is split same as pattern. Use a ball end mill and cut most of the material out of the core half first. Then with a small amount of trig...
Ll Sent from my iPhone using H.A.M.B.
Joe Quick and dirty would be to wax the crap out of the filler tube threads and clean the cap with acetone. Mix epoxy and apply to the inside if...
Joe You need to determine what the thread lead is on the tank (threads per inch). Next you need to determine the diameter (actual) is of the...
Getting to where you can walk on it is one thing. Getting to where you can squat down to change a wheel takes a lot of self rehab. Just keep after...
I have both on my OT TR3. The polycarbonate is used for both the wind wings on the factory windshield and for the wind screens. I just unscrew...
I was at Camp Darby, Italy in the 60s and there was a pretty good auto shop there. There was a minimum rank requirement for private vehicle...
Separate names with a comma.