The Jalopy Journal
If you take the weight off wheel you can move little at time and tighten.
Same amount on each side brings wheel out camber.
What I look for is...
Check your cam timing and maybe get a good stock cam.
You don't seem to want to listen to anyone.
You have spark on not. It really doesn't mean shit how it ran 4 years ago.
Go to speedway and buy a...
I would guess the wheel are in toward the top.
If you put even amount of shims both places should bring wheel out.
Try 1/4 first shot see what...
When testing for spark remove the spark plug wire from dist. cap and hold 1/2" from medal surface. If you test at spark plug it only sparks at one...
I had a 49 303v8 and was always taking the top cover off carb.
The filter is in fuel pump glass remove empty and install.
When removing carb...
I have had 2 c4 that didn't shift right with flathead.
You need the kick down to shift later to 2nd gear.
I shift mine manual with Locker for...
I guess its a Ford rear end 1949 thur 1956
For all the time you been working on car you could have learned how to set points.
That big engine is not a high rpm one, points are ok put the...
Did you ever hear it run.
If not the is a hole in bell housing and ball that top dead center.
When they line up that's tdc
You could be 180...
When you find TDC and marks line up.
TDC both valves maybe closed. Turn half turn.
Now you are on bottom of #1 cylinder.
Now as you turn the...
If you look at the switch in post #2 less then half in being used.
It has some adjustment for motor speed high and low.
To cool this you need...
I think if you get a 1ohm resister with about 10 watt you will be ok.
6 volts and guessing 6 amps, ohms law would be 1 ohm resister.
now add 1...
I would guess its for the mustang II ifs.
I have a 48 and when made there were a lot of about 3" holes in frame.
I guess its to go behind cover...
Separate names with a comma.