The Jalopy Journal
Early Fords (32-34) generally had a greaseable bearing....via a small grease cap on the inspection cover thru a short hose to the bearing....
Curious....what exactly did you mean by the "vent tube"? A 59A type flathead normally vent its crankcase in thru the breather (fuel pump stand) at...
This link on our website will tell you all about it if it's a 3 speed light duty trans. They are synchro into 2nd and high, but not into 1st gear....
Corey...is this the car you guys bought the 39 style tranny for? Mac VP
We normally build just Ford based 3 speed trannies. A year or so ago I rebuilt a stock 57 Chev 3 speed as a spare for a 57 Chev we have. If I...
The case in your pic is an 01A-7006 side loader case. The 78-7006 case would be a top loader with the floor shift. The side loader case will...
Dead coil? An ohmmeter can tell you if you have open windings on the primary and the secondary windings.
You don't say what distributor or coil you have. Let me suggest two possibilities. a) stock 32-41 flathead V8 distributor with its stock (mounted...
The "raised" intake surface did not show up til 1941 models and was discontinued very early in 1942 production.
Shoot me an email....I'll check my stock tomorrow, but I need a note to remind me (not near any notepads right this minute). sales @...
The forks and levers differ between the two styles in several ways and would not generally be considered interchangeable. The key difference is...
Cluster gear from a 49-50 Ford trans (OD or Std) can be used in a 49-50 Merc (OD or Std). Same tooth count......28-24-18-14. There is one...
The 1948 passenger car drums (4" center hole) sell for $95.00 each. We have them in stock.
Subscribed
All cast iron
Separate names with a comma.