The Jalopy Journal
Take it apart and it wil become two one piece shafts. You probably will want to shorten the front shaft at the front, and make sure you keep the...
A guy I went to high school with told me his folks had a 69 caprice with a 427 and a 3 on the tree and l told him no way would somebody order a...
I had a 77 Buick Regal with a 350 olds motor, a buddy bought a 77 regal with a Chevy 350, they called them "corporate motors"
Probably driveshaft hitting rear of frame tunnel, need to raise rear or don't load as heavy, maybe trim frame at rear of tunnel a bit to give you...
Well, it's still trunk trim!
The fourth picture in post #236 was my uncles car! It was built in 1958 and when the original owner got beat in a drag race by a new 59 he sold...
I think Como's post was 2/3 in compression (wheels going up) and 1/3 in rebound (wheels going down). Of course I could be wrong, it's happened...
Maybe a 70s full size dodge or chevy van?
And a generator, 65s got a alternator
I spent all day troubleshooting and replacing parts on a O/T pickup one time and in the end both low beams were burnt out. Boy did I feel dumb...
My 58 came Stock with a 348 4 bbl and p/g had 3.36s
My auto shop teacher (back in the early seventys) told us to always " drag the big shoe"
How about this... http://cacklefest.com/Addict.shtml
58 Chevy mechanical parts are available all over, like napa auto parts or even the big chain stores. Trim and specialty parts are available thru...
You will probably have to run an electric fuel pump, I know some or all EFI motors are not machined for a fuel pump. I don't think the cam has the...
Separate names with a comma.