The Jalopy Journal
Unless you have an special block, small block fords dont have freeze plugs under the bell housing like chevys do. Only place to leak on the back...
Did you make sure your clutch disc didn’t scrape anything? Regular s10 clutch (for me) interfered with the flywheel bolts I remember; so I had to...
Splitting the wishbone will make it a lot easier but you have to make sure you have the good caster because once its all set its hard to add more....
-Electric fuel pump -Let fill carbs -Pump a couple times -turn over and as soon as it pops give it some throttle -get it running and use choke...
It about the same as what the other guy did above. Not sure why the extra material was even there its a non essential area. Its about 3/4” wide...
35 maybe?
[ATTACH] I had to trim my adapter for the counterweights. I personally wouldn’t cut them off the clutch.
Crush sleeves suck, they take alot of power to start crushing them all while hoping you have not gone too far. But after i get it crushing I would...
You could put double nuts on the ends there and just grip on those with the regular socket. Then un do them with a couple hand wrenches. Mark the...
I put a shorter arm from a AA truck (you can get new) on a 30 roadster once and it steered so much better. If the box was rebuilt it would have...
$2500-3000
It adds more fuel to your mixture when your vacuum drops. Its closed at idle and opens at a preset vacuum amount. So when you are cruising along...
Who did the closed driveline conversion on the back?
Holley 94 used on fords through 40s and 50s, Stromberg 97 used on fords in the 30s. Both carbs are 2 barrel design and are the most common carbs...
Separate names with a comma.
The Jalopy Journal
Post
