The Jalopy Journal
Tacked in the first draft of motor mounts. I’m thinking they need a little more beef. I was going for simple, still need to round the edges on the...
Got a little more done! [ATTACH] Rear end is as close as it’s gonna get. Checked pinion angle and square about a hundred times. Re adjusted and...
Thank you Matt..as far as the rubber I have a couple tires that will get me close so I can get my eyeballs on it sooner than later. I need...
Thanks! I agree as well with the bracing, as I mentioned, I originally intended on placing a cross member there, but now It'll get some...
My next hurdles are panhard placement and coil over angles. Feeling like I’m just going to Widdle a bracket coming off the top of the housing. How...
Ended up with a one piece setup that I’ll later cut and weld in a driveline hoop once motor and trans is set. [IMG] Sent from my iPhone using...
Yes it’s definitely giving me the freedom to go as low as I’d like. Although it keeps getting a little higher and higher as time goes by in my...
I ended up really liking the shape the rails took. Wasn’t sure at first, but it’s growing on me. Any thoughts? Parallel bars are pre mades from...
Oh cool Mike. Been chugging along. Got my kick up done for the 4 link in the rear [IMG] Sent from my iPhone using H.A.M.B.
Excellent reading. Thank you very much. This will get me through! Sent from my iPhone using H.A.M.B.
Here’s where I am so far temporary bracing is in, channel about where I like. But where to go from here is anyone’s guess! [IMG] Sent from...
Is it safe to assume there’s a thread regarding wood removal and the different ways these Chevys are braced up? I’m in the process and would LOVE...
[IMG] Sent from my iPhone using H.A.M.B.
Managed to get a shot of the progress of the wood removal and all the temporary bracing going in. You can see the new floor sills starting to...
Separate names with a comma.