The Jalopy Journal
I thought the 300 was going to be for mock up and a 215 aluminum engine was going to be used? You've done an awful lot of work on the 300 though,...
Great work! I haven't found the time to do much on my 61 convertible. Did get a motor and trans -- bought a rolled over 2006 Ranger with 2.3L...
Most people don't know much about the FC Jeeps. They were built on CJ3 frames, that's why the "cab-over" design. The shortest was the F-150 with...
Lots of good work! I'm kinda the resident Rambler guy, but don't get over here that much, missed this!! You can cut the "hump" over the upper...
The 'stang tank can be mounted under the car with straps just like the original tank. The original filler location can be capped over and a new...
My avatar 63 Classic wagon. 1988 4.0L (RENIX computer, Mopar Performance torque cam, 1999 head and intake, 1999 injectors, bored RENIX throttle...
+3 mph at cruising speed is as close as you're going to get with a mechanical speedo -- at least most of them, and especially an at least slightly...
63-66 Classic chassis are identical. Body panels are identical between 63 and 64, and 65 and 66. Mechanically all four years are identical, with...
Reverse lights should be easy. There is a switch at the bottom of the steering column under the dash. That's neutral safety and reverse lights. Of...
Again -- "HE" is an oil engineer at Warren Oil Company: "As far as ZDDP, he stated that current standard motor oil still had some in it, enough to...
When new Ramblers were generally known as economical cars with a lot of value for what you paid. They included some things that were optional on...
I used to write a little magazine about AMC cars (see www.ramblerguy.com). While I was doing that I sent Warren Oil Company, that made house...
Put a small zip tie around the hose at the nipple to tighten it up. Better yet, replace the hose! They stretch and harden with age. If you don't...
If you like that try to find some old automotive text books. I have a few ranging from the 30s to 80s. It's real interesting reading about some of...
Duh!! I forgot. First post mentions a SBC 327 swap. So the only advice I gave that might apply is #2 -- the rubber mounts on the ends of the...
Separate names with a comma.
The Jalopy Journal