The Jalopy Journal
[ATTACH] [ATTACH] Here is what must be the exact same pilot adapter that is shown in the Hot Rod article that Lou posted. Look at post 17 and...
They are Rochester AA carbs. I have run them since 2016 on a 324, .030" over, mild NOS 49-51 303 Crower Hyd cam which I had to use the 1.5 ratio...
2 and 1/2 years late to provide an answer to the 36 case "definitive differences" . I don't post much, and even though this info would only...
Thanks for posting that, I felt like I was the only one. (Just turned 69) Also, you're correct about better weather and SUN. We finally got...
This is fact ^. I tried Fastenal back in October for shipping from Cal to CT, and they only replied "Thank You for your shipping quote request,...
Hi Carp, here's some dragged out vintage car ramblings.... no way to keep it short,, Last Fall when I fixed the blown out exhaust on the 32 Nash...
As already mentioned above, the 57-58 371 is a totally different design engine compared to the 59-60 371. (The cubic inch is the same because the...
49 and 50 303 used the Rochester AA back draft carb that needed a lower profile distributor cap to clear the huge crossways design air cleaner...
that says 4 amp max or to run more in series. I see this one below that is rated 10 amps, 50 watts continuous use, same price. PM Crazy Steve...
Runtz is for low milliamp draw, like gauges, it won't work on blower motors. Next possible thing that may be mentioned is a vintage underdash...
Yes, still using the 32 as a year round primary car, as the only other registered vehicle here is my 66 Chevy K20 that only goes out maybe 3 times...
I can't do that as it goes deeper...see below: Let me try again to explain how the negative comments, AKA "opinions", affect those that come here...
X2. It happens a lot, and sometimes subtle, sometimes in your face, but it's just the fact they had to post something to feel important?,...
If you don't want to use a new crush sleeve, (which can be a real bitch to get it to start to crush)... Pull the seal and small bearing out, and...
As an Edmunds part, it's unlikely to have any numbers. My Olds Edmunds intake only has a B on the underside, and that might be because it was the...
Separate names with a comma.