The Jalopy Journal
gldmountain you were right! I had the 4 way emergency flasher on! In is on! Today was one of those days, chasing a problem only to the find the...
Thank you. It is a 1966 chevrolet chevy II. It does not have a flasher wired in (and the fuse block does not have electrical terminals in the fuse...
Hi everyone, I installed a flaming river steering column. I hooked up the wires to the steering column as reccomended. I checked each old wire...
Just to let you know the result of my endeavor, with the chevy 250 side covers. I spoke to to Tom Lowe at 12bolt.com, and he reccomended a few...
Thank you CNC-Dude. I am going to try Right Stuff gasket maker without a cork gasket. That product is advertised to be used on older vehicles with...
I did the same form 12bolt.com. I have had a little trouble with the side covers leaking when using stock cork gaskets, and 2-4 ft-lbs of torque....
I have the same offenhauser valve cover, and I have had the same issues as MilesM. Three bolt holes had to be drilled oversize to line up, and I...
Thank you!
Thank you Old Wolf
The distributor is spinning, and this motor has metal gears. So, the gears did not shear.
I only cranked it with the starter. I had the 12V and ground disconnected from the distributor. I checked the rotation of the distributor, with...
Thank you. Unfortunately, the tip snapped off my old distributor, taking the oil pump with it, causing this whole mess...
Thank you everyone. I will cut up a flat bladed screwdriver, and spin the oil pump with the valve covers off. Thanks
Hello everyone, I have a chevy 250 L6 in a 1966 chevy C10. I had a problem where the bottom of the distributor shaft snapped off and damage the...
Separate names with a comma.