The Jalopy Journal
You just ordered a 409 V8 & you could get a Pwr. Glide or 4spd with it. Member of my car club has a 65 Custom Sport Parissiene rag top 409 4spd....
Up here the cost to do a US Ponch engine is about 3 times the cost of a SBC. Found that out when I rebuilt the 389 in the 64 Catalina. Thats why I...
Heres what happens up in Ontario Cda.We have a "historic " plate[tag] for vehicles 30yrs & older [$18/yr.] & must be as close to STOCK as it was...
You likely will have to replace all the bushing in the linkage arms & possibly the column!! When they get worn out it's a nightmare trying to...
It would likely help out our American "Cousins" see what we are saying about the Tail lights. I "threw" a lot of people off in West Virginia last...
As streight8 advised may be better to drain the whole thing!! If nothing comes out of block when you open tap, take the tap out & "poke" a small...
Still could be a 327 as the 010 block # fit the bill for 68 & the 302?? Still in the dark here on this one. Pistons are Std. but for what bore??...
I have my "torpedo back sitting on a 84 Cutlass chassis shortened up & the frt. whl. wells moved forward 2" Running a SBC punched out to 358 with...
14 pages & we still don't know "what: it is!!!!!!!! I have to go shave now as I grew a beard reading all 14 pgs.
Have to clarify that Cdn. pontiacs used Chev tail lights up till 54!! Then they took on the look of the US ones in 55, but they still shared the...
The Cdn. Pontiac uses Chevy tail lights [not the round ones that the US uses] thats why i said it's a rebadged Chevy. I'll try to post a pic of...
I don't think anyone's said this yet, but the Cdn. Pontiac is just a re-badged Chevy with Poncho, trim, dash,grille etc. They used the 239 Flatty...
Heres some pics. [i hope ] of TKo 500 in my 52 Cdn/Pontiac. I removed the inp. cover from floor [think 54 has this too] & made small cut to get it...
My neighbour just bought a 60 t/bird 2dt. htp. 352 auto. Rear end has a "howl" in it. Is this a 9" rr. end??? Can't find any sites that state...
I just took a 86 Chevey 4X4 1/2 ton in to scrap steel yard,had extra SBC in back, At $230 a ton came out with just over $550 cash in hand. Line...
Separate names with a comma.