The Jalopy Journal
Why would I think that? Why would I ask a question on a site that has a wealth of information? Why would I look to an older generation of people...
Hello all. I've been working on dialing a 3x2 carb setup in on my 1955 Ford Customline. It's a mild Y-block build. 304ci. Isky cam, gasket-matched...
So after some closer examination. The inner spring is supposed to sit at the same height as the outer spring, which it obviously does not. This is...
I have a thread on yblocksforever.com already. The dampner is brand new and the timing is correct. Sent from my SM-G973U using The H.A.M.B....
Sent a message to Isky. We'll see what they say and I'll report back. Sent from my SM-G973U using The H.A.M.B. mobile app
Update: I got 8, 1.43 ratio rockers resurfaced and installed them on one rocker shaft and then reassembled a shaft with 1.54 rockers to check for...
btt for this one. I'm moving again. Can anyone use this thing? $50?
Check the casting number on the side of the rocker arms as well.
I purchased my Red's headers for $350. I would check to make sure the welds are not broken anywhere, I've had to have mine repaired. I looked up...
Separate names with a comma.
The Jalopy Journal