The Jalopy Journal
Flood the can with propane from an un-lit torch before you close the lid, no oxygen, no moisture= no hardening.
I have not gotten that far yet. My plan is to weld up the cracks and make a sheet metal ring like the tail lights have and plug/spot weld it in....
I have five front fenders total, all of them have cracks around the holes for the bumper irons. Must be too high stress an area to have the...
At only 6 gallons you are going to need to stop for fuel often, pack a Jerry Can. FYI, pre-'57 boat tanks were usually pressurized and had a...
Need a little '40 steering wheel removal help. I have a very nice column, drop, wheel and mast with a tight steering box. Besides needing a good...
Homemade lizard skin, glass micro balloons and acrylic paint can be put on with a regular paint roller.
https://www.youtube.com/playlist?list=PLPwxVM7Kly7O3serfIyE-yJZH_EMMJiXS Check these out. He has a lot more good ones. The earlier ones are...
I really like Summit's DTM sandable epoxy primer. Goes on thick, sands really well, doesn't chip when you bolt stuff together. Previously I had...
Old car bulbs are so dim compared to modern I just drive with high beams on the whole time and never get flashed by oncoming traffic. Recently I...
The strip discs work good. Even better if you have an adjustable speed grinder. They sometimes melt the paint and smear it around when the...
I cant imagine an early 3 speed will last more than 5 seconds behind a 472" motor with 375hp and a whopping 525 torque stock.
About 35 of us went, been a long time since a large part of the crew was out and about. Pretty much filled the small theater about 10 miles...
Thank you. I knew there should be an indent at the bottom but I had no idea the placement or depth. I think I'm about 3/8" too long using your...
Time for an update. I finally finished up the drivers side of the cowl. It took two more patches from where I was last time. I did a Bad Chad...
Fenders and bumpers minus the guards
Separate names with a comma.
The Jalopy Journal