The Jalopy Journal
Find one of the air cleaners that cleans the air by creating ozone, Alpine used to be one brand. Put it inside the car and turn it up to high and...
Being on the edge of the casting like that, it would not be that hard to repair. I think it it were mine and I decided to take a crack at it, I...
By clicking on your name and recent posts, I found three posted recently, not exactly build threads, but had old cad pictures. If these are what...
Put the ign. on a different circuit, or put a diode in the wire that fields the alternator to stop it from backfeeding the ignition.
I ran the same combo for several yrs. and never tied anything off. Never had a problem. I don't guess it would hurt anything, but don't think it...
Not unless the run side of your ignition switch that goes to the coil is somehow wired common with the same part of the power supply. Most modern...
I like the car, but what I really want to know is where Bryan got the picture of my mother? I know it is not her, but could have been her twin in...
You haven't convinced me yet that it is flooding. With no choke it could very well be needing fuel, and when you open the carb, as you put it, you...
Setting in the seat with the trans in neutral, it is left and back to you or down.
If it is a volt gauge there may not be anything wrong, describing it as returning straight up, make me think it might be an amp gauge, if so it...
Audacity has nothing to do with it, I know nothing about your ability or other qualities. I responded to your words in the first post, and it is...
Well if we are going to count customers cars, I probably had over a hundred failures over the yrs., never kept count, and yes I occasionally...
Can't tell from your picture whether the solenoid is bolted to the frame or not, with a modern solenoid that needs voltage to energize it needs to be.
I don't think I would want you doing the maintenance on my vehicles, that is a lot of failures, you ought to keep the brake systems up in shape. I...
You have got some good advice already, I would add that if the valves were sealing good and you are not going whole hog with a valve job, then...
Separate names with a comma.